35 spindle construction boring machine. Quick change chucks are standard(10). Spindle mounted in gear head with two sealed ball bearings. Hardened steel gear pressed onto spindle. Spindles are 32mm on center. 35 spindles are driven by two 2hp motors. Head tilts from 0-90 degrees(vertical to horizontal) pneumatically. Machine is equipped with stop at 45 degrees for head tilt. Pneumatic movement of boring head via foot pedal. Three pneumatic hold downs that automatically activate when machine is cycled. Grease fitting on boring head. Equipped with 86" back fence. Equipped with two lateral fences. One 39" extension. Four flip stops. Mirror imaging device(to set lateral fences). One mechanical digital read0out for drill bit position. Special plate for drilling a 45 degree miter. One index pin for line boring. Tool set included.

Electrical connection: 15amps at 220 volt, 3 phase
Air: 4cfm at 90psi
Spindle distance: 32mm(1-1/4")
Gear diameter: 1-3/8"o.d. x 1-1/2 wide
Length of back fence: 86"
Table size: 24" x 44-1/2"
Table height: 36"
Width of machine: 45"- with back fence at 86"
Depth of machine: 45"
Weight: 1205 lbs.