This machine is equipped with 4 stations: End Trim, Top & Bottom Trimming Scrape and Buffing. Entry-level, fully automatic edgebander. Large coil table for roll material. Automatic roll cutter & strip feed magazine. Quick changeover for rolls or strip material. Standard guillotine for cutting up to 3mm PVC from the coil(max height of 35mm). Quickmelt glue pot with quick change disconnect for ease of maintenance or glue color change it required. 10-15 minutes heat-up time(depending upon voltage). Digital thermostat with approaching temperature control PDI and auto temperature drop. Pressure station with one motorized pressure roller plus 2 additional pressure roller. End trim station, single motor with double blades. Top & bottom with digital(s) and combination bevel and radius carbide insert tooling. Scrape station. Buffing station. Electronic programmable logic control(PLC). High frequency motors on end trim(top & bottom trim units). Digital on top of pressure beam for height indication. Digital on pressure station. Digital on top & bottom trim station. Fixed speed at 33 feet per minute. 220 volt/ 3 phase(+/-%, depending on voltage)

Coil cutoff maximum: 3mm PVC
Edgeband thickness max: 3mm
Panel length min: 5" (120mm)
Panel width min: 3" (75mm)
Panel thickness min: 3/8" (8mm)
Panel thickness max: 1-3/4" (45mm)
Feed speed: 33FPM
Feed motor: 1hp/.75kw
Pressure section: 1 motorized roller with 2 additional roller
End trim unit-one motor: 1/3hp /.27kw
Tooling speed: 12,000RPM
Straight cut max: 1/8" x 2"
Top & Bottom trim station: 1/3hp /.27kw
Total power required(amps): 17 amps at 220 volt, 3 phase
Machine length: 10' (2760mm)
Machine width: 56"-80" depending on outrigger position
Working height: 32-1/2"
Total height: 50-1/2" (1280mm)
Machine weight: 1873 lbs.