This machine is equipped with 6 stations: Premill, End treim, 1st top & bottom trimming, 2nd top & bottom trimming, Radius scrape, and Buffing. Two motor premill station. Large coil table for 3mm PVC. Automatic roll cutter & strip feed magazine. Quick changeover for rolls or strip material. Heavy-duty guillotine for cutting up to 4mm PVC from the coil. Quickmelt glue pot with quick change disconnect for ease of maintenance or glue color change if required. 10-15 minutes heat-up time(depending upon voltage). Swivel control panel located on infeed end of machine for easy access. Pneumatic position system executed from the control panel for the follwoing functions: Flush or bevel end trim station, 2nd top & bottom trim station, radius scrape station.
Pneumatic pressure station with motorized pressure roller plus 2 additional pressure rollers. End trim station, double motor, tiltable with beveling up to 10 degrees. 1st top & bottom hogging station equipped with digitals and straight insert tooling(for flush trimming). 2nd super finish tiltable top & bottom trim station equipped with digitals and combination insert tooling for flush, bevel & 3mm radius trimming. Radius scrape station for 3mm PVC. Top & bottom oscillating compound buffing station. Welded block frame. Electronic programmable logic control(PLC). Digital on top pressure beam for height indication. Digital on pressure station. Digital on top & bottom trim stations. Digital on scrap station. Variable speed at 30-60 feet per minute. 220 volt/3 phase(+/-%, depending on voltage).

Coil cutoff maximum: 4mm PVC
Edgeband thickness max: 3/8" solid wood
Panel length min: 5" (120mm)
Panel width min: 3" (8mm)
Panel thickness min: 3/8" (8mm)
Panel thickness max: 2" (50mm)
Panel thickness max with premill: 1-1/8" (30mm)
Feed speed: 30-60FPM
Feed motor: 2.3hp/1.73kw
Pre mill hp: 2 motors-2hp each
Pressure section: 1 motorized roller with 2 additional rollers
End trim unit-two motors:1/3 hp /.27kw
Beveling range: 1-10 degrees
Tooling speed: 12,000RPM
Straight cut max: 3/8" x 2-1/4"
1st & 2nd finish top & bottom trim station: 3/4hp /.55kw
Tilting range: 0-20 degrees
Total power required(amps): 30amps at 230 volt, 3 phase
Machine length: 17.5' (5220mm)
Machine width: 56" -80" depending on outrigger position
Working height: 32-1/2"
Total height: 57" (1440)
Machine Weight: 4500lbs.